Remotely manageable alarm monitoring communicator with WiFi connection 

Send Contact-ID events of the alarm control panels to an IP telemonitoring (in SIA DC-09 format), and/or forwards the message related to the event, in “push notification” format to mobile (Android) devices.

With the free application, the alarm control panel can be controlled (open/close), and its signals can be seen selectively (by user, zone, partition).
Unlimited number of signals and free operation.  

Signaling exclusively depends on the existence of the permanent WiFi connection, thus several WiFi access points can be set up to handle any possible router or service errors.

No router setup needed during installation.

   2 WiFi networks (main and alternate signaling path) can be set up
   2 controllable outputs (from the WEB or from a smartphone application)
   Contact-ID signaling to 2 independent SIA DC-09 telemonitoring receivers
   AES-128 encrypted communication
   Serial port for remote programming of alarm panels
   Headphones output to listen to Contact-ID communication
   Parameter setting and firmware upgrade remotely using a WEB browser
   Setting from WEB interface using hotspot mode
   Setup from a WEB interface, using the Internet
   No mobile provider and no SIM card needed
   Unlimited number of signals
   Simple installation (no router setup needed)
   Standardized communication, wide range (IEEE 802.11 b/g/n)
   Signaling of Contact ID event codes of alarm control panels
   Remote programming of alarm control panels and fire alarm control panels over the Internet
   Complete control of the alarm control panel from a smartphone
User's manual
CE certificate
Configurator program (for v1.13.147 firmware version or above)   
Version: v2.11
Win 7
Win 8
Win 10
   Alarm Over IP
   IoT in signaling technique
Loop current25mA
Power9-30V DC
Impedance100-470 Ohm
Dial tone425 Hz
Line voltage48V
Operating temperature0 … +70°C
Dimension75 x 80 x 25 mm