SINGULAR W3G
Remotely manageable alarm monitoring communicator with WiFi primary and HSPA backup connection

The device interprets Contact-ID or SIA FSK protocol (over simulated phone line), and translates to SIA DC-09 IP-based format, then sends it to the address of the set-up telemonitoring receivers.

Signaling exclusively depends on the existence of the permanent WiFi connection, thus several WiFi access points can be set up to handle any possible router or service errors.

In order to keep the higher security level, has 3G mobile communication extension, too.

   Setup using a WEB browser, on a platform independent mobile phone or PC
   Remote serial connection with almost any security or fire alarm control panel
   Smartphone controllable on the outputs of the contact, open/close, on a maximum of 2 partitions
   Listen to communication on TIP/RING line to make installation easier
   Primary WiFi and alternate HSPA/GPRS connection
   Minimum communication cost, only for alternate signaling
   Wide range (WIFI 802.11 b/g/n)
   Advanced 3G network connection
   Physical phone line (TIP/RING) emulation for the alarm panel
   Forwards Contact ID signals of the alarm panel towards the IP receiver
    Audio output in order to check the communication on emulated phone line
User's manual
Configurator program (for v1.13.147 firmware version or above)   
Win 7
Win 8
Win 10
   Alarm Over IP
   IoT in signaling technique
WLAN2.4GHz
Cellular BandsHSPA (800/ 850/ 900/ 1900/ 2100MHz)
Loop current25mA
Power9-30V DC
Impedance100-470 Ohm
Dial tone425 Hz
Line voltage48V
Operating temperature0 … +70°C
Dimension75 x 90 x 25 mm